Eureka Tents Tent Scenic Pass XT User Manual

With the tent secure, drape the fly over the tent body. The fly  
only fits on the tent one way. Position the fly over the tent with  
the vestibule sections over the doors. Reach under the fly and  
connect the hook and loop tabs to the tent poles. See fig. 8.  
B
C
ASSEMBLY INSTRUCTIONS  
SCENIC PASS XT TENTS:  
Component List:  
1 Tent Body, 2 Tent Poles, 1 Tent Fly, 1 Carry Bag,  
1 Pole Bag, 1 Stake Bag/ Stakes  
Connect the four corner buckles on the fly to their mates on the  
tent webs. Do not fully tighten down any of the webs just yet.  
See fig 8.  
A
fig. 3  
D
Unroll and unfold the tent with the floor on the ground.  
Remove the fly and set it aside. Do not stake the tent down  
yet. In windy conditions, we recommend that a narrow end  
should face into the wind and that you stake down one  
corner of this end. See fig.1  
Join the shock-corded poles together. Try to prevent pole  
sections from snapping together, as this can damage the  
pole ends. Make certain each insert end has seated firmly  
into each plain end.  
Raise up the tent poles and attach the  
peak of the tent to them. Capture both  
poles where they cross, with the loop and  
dog bone. See fig. 4 & 5.  
fig.8  
fig.9  
fig. 4  
B
C
At the front of the tent, pull the stake out loops on the vestibule  
taut and stake them down. Make sure that the vestibule is tight  
across the door. Repeat with the other vestibule at the rear of  
the tent. See fig. 10.  
fig. 5  
A
D
fig. 1  
Attach all the clips to the poles. Your tent is now free-standing,  
place it in location that has enough room for the fly and stake it  
At the front corner of the tent;  
down through the corner loops. Stake the opposite corners while  
applying tension to smooth the floor wrinkles. See fig. 6 & 7  
[with the yellow web]- A, fit  
the post end of one of the  
aluminum poles into the web  
grommet. Angle the pole to  
the opposite corner;  
At corner , repeat with the  
second pole to  
A
to  
C.  
B
fig.10  
fig. 2  
B
D.  
With the vestibule wing sections staked down and tight, go  
around the tent, and adjust or tighten all the side release  
buckles.  
Start at the front of the tent at  
and grasp the end of the  
pole in one hand and the web loop in the other. Push the pole  
from to creating an arc. Insert the post into the web grommet  
to tension the tent across the diagonal. Repeat with the other  
pole; to . See fig. 2 & 3.  
D
Your tent is now ready for use.  
D
B
NOTE:  
C
A
fig. 7  
fig. 6  
In strong winds, tie extra ropes to the storm loops on the fly and  
stake down so that the ropes are tight.  
REV A 4.09  
 

3Com Network Card 3CR990 TX 95 User Manual
3Com Network Card PC Card User Manual
Acoustic Research Home Theater System ARHC4 User Manual
Adcom Home Theater System GFP 815 User Manual
Aiwa CD Player AM C75 User Manual
Alloy Computer Products Network Card WDS2454AP User Manual
Amana Refrigerator AFI2538AEW User Manual
AmbiCom Network Router WL11 SD User Manual
Asus Computer Accessories AP100 User Manual
Eureka Tents Tent Scenic Pass XT User Manual